Foundation Repair Before & After Photos

A homeowner in Duluth, MN had a concrete block garage wall that was in rough condition. As the blocks wear down overtime, they can begin to move and shift in unwanted directions. In need of a solution to prevent further damages, the owner reached out to DBS. It was decided that the best possible measure would be to install the CarbonArmor® Wall Reinforcing System along the garage. This product is an ideal solution to failing foundation walls. The installation was a success, and the homeowner can now be more comfortable with an updated garage area. 

A homeowner in Duluth, MN reached out to DBS regarding several areas of their basement needing to be worked on. One corner of the basement had an old sump pump that they were looking to upgrade, in order to have a more efficient waterproofing system. Along with that, the foundation walls in the basement were in need of more adequate support. For this, the crew installed the CarbonArmor® Wall Reinforcing System. This is an ideal product for optimal wall stabilization. The results of the installation can be viewed in the photos attached.

This homeowner in Duluth, MN had bowing walls in the basement. Over time, this caused an issue with moisture and damaged the basement paneling. After learning about DBS and our wall stabilization service, they reached out to schedule a free, no-obligation estimate. 

DBS Design Specialist Nathan Schroeder visited the home, inspecting both the interior and exterior of the foundation walls. Upon assessing the scope of the wall movement, he designed a plan to permanently stabilize the walls using 6 PowerBrace™ steel I-beams. 

DBS Foundation Repair Foreman Trevor Ingle and his crew installed the PowerBrace™ system. Attaching the vertical supports to the ceiling joists and concrete floor, this system immediately stabilized the walls. Over time, the PowerBrace™ beams can be tightened to restore the wall to its original position.

These Duluth, MN homeowners reached out to DBS when their basement walls began to crack and bow.

DBS Design Specialist Royce Bunn went to the property and provided a free, no-obligation estimate for the work.
Foreman Kevin Steffey and his production crew installed our PowerBrace™ Wall Bracing System to immediately stabilize the bowing walls. Over time the PowerBrace® System is tightened by our service team to restore the wall to level.

This basement is now permanently stabilized and safe for the family to enjoy.

This home in Duluth, MN was suffering from bowing foundation walls in the basement of the home. The owner wanted to stabilize these walls and correct the caving.

Design Specialist Jake Gilmer assisted the owner with a free, no-obligation estimate. After a careful inspection, Jake recommended our GeoLock™ Wall Anchoring System.

Foreman Osia Williams led the installation of this project with help from Rowan Wentworth. Together, the duo excavated around the outside of the home. The earth anchors are installed outside of the home, below the ground, and the steel plates are installed inside the home on the bowing wall. These systems are connected using a steel rod and can be adjusted in order to restore the wall to its original position.

This homeowner can now relax knowing their home is safe and secure.